Mada za sehemu hiiManaging soil erosionMada 3
- Controlling soil erosion
- Identifying types of soil erosion
- Performing conservation agriculture (CA)
Soil erosion control means using methods that prevent or reduce the removal of topsoil by water, wind, or human activities. The goal is to keep the fertile top layer of soil in place so that crops can grow well. Good erosion control starts with understanding the factors that cause erosion and then choosing the right methods to stop it.
Several factors make soil more likely to be eroded:
- Steep slope: Water moves faster downhill, carrying soil with it.
- Bare soil: Soil without plant cover is easily washed or blown away.
- Heavy rainfall: Intense raindrops break down soil particles quickly.
- Lack of vegetation: Roots normally hold soil particles together.
- Poor farming practices: Ploughing up and down slopes speeds up runoff.
Understanding these factors helps farmers choose the most appropriate control method for their land.
Before choosing a method, walk over the field, preferably just after rain, and look for the signs and types of erosion:
- Splash erosion – raindrops knock soil particles loose; soil is splashed onto stems and leaves.
- Sheet erosion – a thin, even layer of topsoil is washed away; the soil becomes paler and stones and roots are left showing.
- Rill erosion – small channels, a few centimetres deep, cut by running water.
- Gully erosion – deep channels that cannot be removed by normal cultivation.
- Wind erosion – dry, loose soil is blown away, mostly from bare, open land.
Then measure the slope, because the steepness decides which method to use.
Slope (%)=horizontal distancevertical drop×100
To measure it, drive a peg at an upper point and stand a staff or ranging pole at a lower point 10 metres away, measured with the tape held level. Stretch a string from the foot of the upper peg to the staff, use the line level to make the string level, and measure how high the string is above the ground at the staff. That height is the vertical drop.
Example: the string is 0.8 m above the ground at a staff 10 m away. Slope =100.8×100=8%.
There are two main categories of erosion control methods: agronomic or biological methods and mechanical or engineering methods.
1. Agronomic (Biological) Methods
These methods use plants and natural materials to protect the soil.
- Cover cropping: Growing low, spreading crops such as cowpeas, lablab, velvet bean or sweet potato vines between seasons or between crop rows to keep the soil covered. The plant roots bind soil particles together and the leaves break the force of rainfall.
- Mulching: Spreading organic materials such as grass clippings, straw, or crop residues over bare soil. Mulch protects the soil surface from raindrops and reduces the speed of runoff water.
- Contour farming: Ploughing, planting, and cultivating across the slope, along the contour lines (lines that join points of the same height), rather than up and down the slope. Contour ridges slow down water as it flows downhill.
- Crop rotation: Growing different crops in sequence on the same piece of land. Different root systems improve soil structure and reduce erosion.
- Intercropping: Planting two or more crops together so that the land remains covered throughout the year.
- Strip cropping: Growing crops in alternating strips across the slope, so that a strip of a close-growing crop such as grass, beans or groundnuts lies below each strip of a widely spaced crop such as maize or tomatoes. Soil washed from one strip is trapped by the next.
- Grass strips and buffer strips: Leaving or planting bands of grass about a metre wide along the contour, and a wider band of permanent grass, shrubs or trees (a buffer strip) along the lower edge of the field and beside streams. Suitable grasses include vetiver grass, Napier (elephant) grass and Guatemala grass. The roots hold the soil, and the stems slow runoff and filter out the soil it carries.
- Minimum tillage: Disturbing the soil as little as possible, for example by digging only the planting holes or planting lines and leaving the rest of the surface covered with crop residues.
- Zero tillage: Not ploughing at all. Weeds are slashed or otherwise controlled, residues are left as mulch, and seeds or seedlings are planted directly through the mulch.
- Shelter belts (windbreaks): Planting one or more rows of trees or tall shrubs across the direction of the main wind to slow it down and protect soil and crops from wind erosion.
- Afforestation: Planting trees or shrubs on steep or bare land. Tree roots bind the soil firmly and the canopy breaks the impact of rainfall.
2. Mechanical (Engineering) Methods
These methods use physical structures to control water flow and hold soil in place.
- Contour bunds and ridges: Low banks of soil built along the contour on gentle to moderate slopes to hold back water so that it soaks in.
- Terraces: Steps built across the slope to slow down water and trap soil. On steep slopes, bench terraces turn the hillside into a series of level steps. A terrace can also be formed gradually by digging a trench along the contour and throwing the soil uphill to make a bank (known in East Africa as fanya juu); soil collects behind the bank and a bench forms over the seasons.
- Stone lines: Placing stones along contour lines on gentle slopes. Stones break the flow of water and encourage soil to settle behind them.
- Cut-off (diversion) drains: A channel dug across the slope above the field to catch runoff coming from higher land and lead it gently away to a grassed waterway or natural drain, so that it does not rush through the crop.
- Gully reclamation: Healing a gully in steps. First divert the water that feeds it with a cut-off drain. Then build check dams across the gully: small barriers of stones, poles or brushwood, lower in the middle than at the sides so that water spills over the centre and does not cut round the ends. Finally plant grass, shrubs or trees on the gully sides and on the soil trapped behind the dams, and keep livestock out.
The best method depends on several conditions:
| Condition | Recommended Method |
|---|---|
| Gentle slope, small area | Grass strips, mulching |
| Moderate slope | Contour bunds, strip cropping, stone lines |
| Steep slope | Bench terraces, tree planting, permanent grass cover |
| Runoff entering from higher land | Cut-off (diversion) drain |
| Gullies | Gully reclamation with check dams and planting |
| Heavy rainfall area | Cover cropping, mulching, minimum or zero tillage |
| Crops grown in rows | Contour farming |
| Bare land needing quick cover | Cover cropping, mulching |
| Open, windy land | Shelter belts |
A farmer should assess the slope gradient, soil type, amount of rainfall, and type of crop before deciding which method or combination of methods to use.
A farmer in Mwanza has a field with a gentle slope that has been losing topsoil every rainy season. The farmer notices that water runs quickly down the slope, carrying dark fertile soil away. Which two methods would be most suitable and why?
Answer: The farmer should use contour farming and mulching.
- Contour farming will break the flow of water by creating ridges across the slope, making water spread out and soak into the soil instead of running downhill.
- Mulching with grass clippings or crop residues will protect the soil surface from raindrop impact and slow down surface runoff.
Together, these two methods are low-cost, use locally available materials, and are easy to apply on a gentle slope.
- Fix a string between two poles at exactly the same height on each pole, and hang the line level at the middle of the string.
- Start at one side of the field. Hold the first pole upright at a peg. A partner walks across the slope with the second pole until the string is tight, then moves it a little uphill or downhill until the bubble of the line level is in the centre. The feet of the two poles are now at the same height. Drive a peg at the second pole.
- Bring the first pole to the new peg and repeat across the field. The line of pegs is a contour line. Smooth out any sharp bends.
- Mark more contour lines further down the slope. The steeper the slope, the closer together they must be. A common guide is a drop of about 1 metre in height from one line to the next: about 20 metres apart on a 5% slope and about 10 metres apart on a 10% slope.
- Dig a shallow channel along each marked contour line.
- Place the excavated soil on the downhill side of the channel to form a ridge or bund.
- Compact the ridge lightly so that it holds water and slows runoff effectively.
- Plant grass or cover crops on the ridge to stabilise it with roots.
Using tools such as a line level, ranging poles, pegs, a tape measure, and a hoe makes the work accurate and efficient.
- Wear gum boots, gloves and overalls, and safety glasses when breaking stones or digging hard ground.
- Carry hoes, mattocks, spades and machetes with the blade pointing down, and keep a safe distance from other workers when swinging a tool.
- Carry ranging poles upright with the pointed end down and never throw them. Lift stones with bent knees and a straight back, and use a wheelbarrow for heavy loads.
- Handle levels and tape measures gently. Keep an automatic level in its box when it is not in use, never leave it standing unattended on its tripod, and keep survey equipment out of the rain.
- After work, wash or scrape the soil off all tools, dry them, and wipe metal parts with an oily cloth to prevent rust. Wipe and rewind tape measures and coil ropes.
- Store tools on racks in a dry, locked store, with sharp edges facing the wall.
- Erosion removes the fertile top layer of soil, reducing crop yields.
- Control methods are either agronomic (using plants) or mechanical (using structures).
- Contour-based methods work well on sloping land.
- Combining two or more methods is often more effective than using one alone.
- Regular maintenance of terraces, stone lines, and grass strips is necessary for long-term protection.
- Safety gear such as gum boots, gloves, and overalls should be worn when working in the field.
A small-scale tomato farmer in Morogoro with a gently sloping plot can use contour farming and mulching to protect the soil during the long rainy season. By ploughing along the contour and covering bare soil between tomato rows with grass mulch, the farmer reduces topsoil loss, keeps the field productive for longer, and avoids the cost of buying extra fertiliser to replace lost nutrients.
Jinsi utakavyotathminiwaTathmini ya mchakato · Tathmini ya matokeo · Tathmini ya maarifa
Tathmini ya mchakato
The student should be able to:
- Select working tools, equipment and safety gear
- Investigate the crop field
- Select plants to control erosion
- Determine the slope percentage
- Make a contour bund
- Perform strip-cropping
- Construct terraces
- Perform gully reclamation
- Make shelter belts.
- Make a buffer strip
- Perform zero tillage
- Perform minimum tillage
- Perform crop rotation
- Plant cover crops
- Observe safety precaution of handling tools and equipment
- Clean tools and equipment
- Store tools and equipment properly
Tathmini ya matokeo
Soil erosion is controlled as per laid down agronomic practices
Tathmini ya maarifa
Knowledge evidence:
Detailed knowledge of:
Method used: The student should explain how to control soil erosion using contour ridges and terraces.
Principles: The students should explain the principles of soil erosion control
Theories: The students should explain the:
- Soil erosion
- Type of soil erosion
- Causes of soil erosion
- Soil erosion control measures
- Importance of Soil erosion control
- Effects of soil erosion
- Terrace contour ridge
- Runoff diversion
- Methods of protect Steep Slopes
- Types of plants (grasses) to control soil erosion
- Importance of mulching
- Importance of crop rotation in soil erosion control
Circumstantial knowledge: Detailed Knowledge about safety precautions of using land survey equipment
Swali
Soil erosion control methods are grouped into which two main categories?
Ingia ili kuwasilisha jibu lako na lihesabiwe katika umahiri wako.
Ingia ili kufanya mazoeziMwalimu
Umekwama? Niulize chochote kuhusu mada hii.
Ingia ili kumuuliza Mwalimu wa AI wa Sonza kuhusu swali hili.
Ingia ili kuulizaMajadiliano
Hakuna maswali bado