Step 1: Form the First Loop
Starting at the bottom of the warping board, put your hand through the loop that is formed. This loop was created when you finished winding the warp.
Step 2: Draw the Warp Through
Bring your hand through and take hold of the warp, drawing it through the loop. This creates the first link of your chain.
Step 3: Repeat the Process
Then put your hand through the new loop that is formed and pull the warp through again, forming a new loop. Repeat this action until you reach the end of the warp. Each repetition creates another link in the chain, keeping all threads parallel and organized.
Step 4: Secure the Chain with Bow Knots
Secure your warp chain with choke ties placed about every yard along the warp chain and on the ends. Wrap each tie twice around the entire chain, and use bow knots rather than square knots. Bow knots are easier to untie when you are ready to use the warp.
Step 5: Use Counting Thread at the Cross
Starting at the back of the cross (where the counting thread loops around), count out a 1-inch section of warp threads. Separate these threads from the others slightly and pull the ends of the counting thread through that opening, then overlap to trap the warp ends. Continue until you have the entire cross in sections with the counting thread and secure with a bow knot.
Step 6: Prepare Lease Sticks for Threading
Use paper to tie the top two warp layers on each side of the cross. Fold pieces of paper around the upper warp layers and secure them with a pin. Insert your lease sticks by simply lifting the pieces of paper to create an opening between top and bottom layers. After you have inserted the lease sticks on both sides of the cross, remove the paper and store it for your next warp.
Step 7: Secure Lease Sticks for Sleying
Place your lease sticks through your cross and use hook and loop straps to attach them to your front beam while sleying the reed. Pull the bottom yarn above the top yarn, creating an opening, and insert one end of a lease stick. Repeat on the other side. Pull the bottom thread up again to create a second opening (the two openings will make a figure eight in the yarn) and insert the end of the second lease stick. After threading, remove the lease sticks and undo the ties.