A multimeter is a device that combines several measurement functions — including resistance measurement — in one tool. To measure resistance, we use the ohmmeter function (Ω symbol) on the multimeter.
Steps to Measure Resistance
Step 1: Turn Off the Power
Before measuring resistance, always ensure the power source to the circuit is turned off. This prevents inaccurate readings and protects the multimeter from damage.
Step 2: Select the Appropriate Range
Set the multimeter to the resistance (ohms) measurement mode. Choose a range that is equal to or greater than the expected resistance. For example, if you expect a resistance of about 100Ω, select the 200Ω or 1000Ω range.
Step 3: Disconnect the Resistor (if needed)
If the resistor is easily accessible, you can measure it in place. However, if the resistor is difficult to reach or you need a more accurate reading, disconnect it from the circuit first.
Step 4: Connect the Test Leads
Connect the multimeter probes to the terminals of the resistor. Since resistors are non-polarized, it does not matter which probe goes to which terminal.
Step 5: Read the Display
Read the resistance value displayed on the multimeter screen. The reading will be in ohms (Ω).
Step 6: Record the Reading
Note down the resistance value for reference.
Step 7: Reconnect and Restore Power
If you removed the resistor, reinstall it in its original position. Turn the power back on if needed.
Important Note
When measuring resistance in-circuit (without removing the component), the reading may include the resistance of other components connected in parallel. This can make the measured value different from the resistor's labeled value. For the most accurate measurement, remove the resistor from the circuit first.