Step 1: Preparation and Measurement
Measure the length of the eave along the wall to determine the required length of fascia boards. Use a tape measure and record the total length, adding extra for waste cuts at corners.
Step 2: Marking and Cutting Fascia Board
Mark the fascia board to the required length using a try square and pencil. Cut the board to size using a hand saw, ensuring square ends for neat joints at corners.
Step 3: Fixing the Soffit Board
Fit the soffit board first, if applicable. Position it horizontally or at the required slope between the wall and where the fascia will sit. Secure it with nails driven into the wall plate or structural framing.
Step 4: Fixing the Fascia Board
Hold the fascia board in position, ensuring it is vertical (checked with a spirit level) and flush with the wall surface. The top edge should sit tightly against the rafter ends or wall plate. Nail securely through the fascia into the rafter ends or wall plate at regular intervals.
Step 5: Joining at Corners
At external corners, cut the fascia boards at a 45-degree angle to form a neat mitred joint. Use a sliding bevel to set the correct angle before cutting.
Step 6: Checking Alignment
Use a spirit level to verify that the fascia is truly vertical and the eave line is straight. Make any necessary adjustments before final fixing.