Mada za sehemu hiiPerforming land surveyingMada 5
- Carrying out chain survey
- Carrying out compass survey
- Carrying out levelling survey
- Carrying out contour survey
- Using GPS to plot different survey data
A Global Positioning System (GPS) receiver captures coordinates from satellites and uses them to plot points, lines, and areas on a digital map. In land surveying for agriculture, GPS allows us to measure fields, mark boundaries, and record elevation data quickly and accurately without traditional tape-and-string methods.
GPS stands for Global Positioning System — a network of satellites orbiting the Earth that continuously send signals down to receivers on the ground. A GPS device (also called a GNSS receiver) picks up these signals and calculates its exact position in terms of:
- Latitude — how far north or south of the equator it is
- Longitude — how far east or west of the prime meridian it is
- Elevation (Altitude) — how high above sea level the point is
These three values together are called coordinates.
In land surveying, GPS equipment is used to:
- Mark property corner pins and boundaries
- Plot the perimeter of a farm plot or grazing area
- Record elevation data for drainage planning
- Create digital maps of land features
- Record where soil samples were taken or where pests, weeds or poor growth were seen, so the spots can be found again
- Guide tractors and sprayers along straight, evenly spaced passes
- Navigate back to saved points (waypoints) so that existing markers can be found again
When using GPS for surveying, the following equipment should be prepared:
- GNSS/GPS receiver (handheld or pole-mounted)
- Prism poles or tripods to hold the GPS receiver steady
- Marking paint or land surveying markers to mark points on the ground
- Surveyor's roll flagging to flag areas
- Data collector or smartphone/tablet to store coordinates
- Overall (protective clothing)
- Bags and cases for transport
Follow these steps carefully:
- Prepare the GPS equipment — check battery charge, ensure the receiver is working, and load any required mapping software.
- Set up the receiver on a tripod or prism pole — place it on a stable, flat surface. The pole should be held vertically so readings are accurate.
- Create or open a new survey project — name the project (for example, "Mwanza Farm Survey") and set the coordinate system.
- Mark and record waypoints — walk to each point you need to plot (such as a corner pin or fence post) and press the button to save the coordinate. Type a name for the point (e.g., "A — north-west corner") and write the name and coordinates in your field notebook.
- Plot lines between points — connect consecutive waypoints to trace boundaries or transect lines.
- Calculate area — use the GPS software to calculate the area enclosed by your plotted points. Most units display area in square metres or hectares.
- Save and export data — transfer the recorded points to a computer by cable, memory card or Bluetooth, usually as a GPX, KML or CSV file.
- Plot the data with software — open the file in mapping (GIS) software. The points appear on a map; join them to draw the boundary, label each point, let the software calculate the area, then save or print the map.
A farmer in Morogoro wants to survey a rectangular maize field using GPS. The surveyor marks four corner points:
| Point | Latitude | Longitude | Elevation (m) |
|---|---|---|---|
| A | 6.8231° S | 37.6500° E | 512 |
| B | 6.8231° S | 37.6515° E | 513 |
| C | 6.8245° S | 37.6515° E | 514 |
| D | 6.8245° S | 37.6500° E | 513 |
Using the GPS software:
- The system draws lines connecting A → B → C → D → A.
- It calculates the area enclosed: approximately 2.6 hectares (the field is about 166 m by 155 m).
- It also shows that the land slopes gently from the south-east corner (514 m) to the north-west corner (512 m), so water runs towards the north-west corner, where a simple drainage channel is needed. (Heights from a handheld GPS are only approximate, so confirm small slopes with a level.)
This data helps the farmer plan planting rows across the slope and estimate the correct amount of seed and fertiliser needed.
- Wear overall and sturdy shoes when walking through fields during survey work.
- Be aware of uneven ground, holes, or irrigation ditches.
- Protect GPS equipment from rain and dust.
- Do not operate GPS near strong electromagnetic sources that may interfere with signals.
- Wipe dust and mud off the receiver, poles and tripod and dry them before packing
- Switch off the receiver, recharge the batteries, and store the equipment in its bags and cases in a dry, secure place
- Collect used flagging tape, empty marking-paint cans and dead batteries and dispose of them properly. Do not leave them in the field
- GPS provides latitude, longitude, and elevation coordinates for any point on Earth.
- A GPS receiver must be held steady and vertical when taking a reading.
- Plotted points can be connected to form boundaries, and software can calculate the area.
- GPS is much faster than tape methods over large areas. A handheld receiver is accurate only to a few metres, so precise boundary work needs survey-grade GNSS equipment.
- Always label points clearly and record them in a field notebook as backup.
A small-scale tomato farmer in Arusha can use GPS to survey his one-hectare plot before the rainy season. By plotting the field corners and checking elevation data, he identifies the lowest corner where water collects and decides to dig a small drainage furrow there. He also uses the area calculation to work out how many tomato seedlings and how much fertiliser to order, avoiding both waste and shortage. This practical use of GPS saves time, reduces guesswork, and helps the farmer invest his money wisely before planting.
Jinsi utakavyotathminiwaTathmini ya mchakato · Tathmini ya matokeo · Tathmini ya maarifa
Tathmini ya mchakato
Students should be able to:
- Interpret technical drawings.
- Use service manuals.
- Select tools and equipment.
- Use GPS to plot different survey data
- Observe safety precautions
- Clean tools, equipment and work place.
- Store tools and equipment.
Tathmini ya matokeo
Land surveying according to Technical specifications.
Tathmini ya maarifa
Knowledge evidence:
Detailed knowledge of:
Methods used: Students should explain how to:
- Use GPS tools.
Principles: Students should explain the principle of:
- Collect data using GPS
- Record GPS data
- Use software to plot GPS data
Theories: Students should:
- Explain uses of Global Positioning System instrument in agricultural.
Circumstantial knowledge:
Detailed knowledge about:
- Safety precautions while Using GPS to plot different survey data tools.
- Safe handling of working tools and equipment.
- Waste disposal.
Swali
What does the abbreviation GPS stand for?
Ingia ili kuwasilisha jibu lako na lihesabiwe katika umahiri wako.
Ingia ili kufanya mazoeziMwalimu
Umekwama? Niulize chochote kuhusu mada hii.
Ingia ili kumuuliza Mwalimu wa AI wa Sonza kuhusu swali hili.
Ingia ili kuulizaMajadiliano
Hakuna maswali bado