Mada za sehemu hiiDehairing raw hides and skinMada 5
- Preparing lime solution
- Dipping hides and skins
- Performing stage beams
- Scraping hair out
- Removing lime
Dipping is the process of immersing hides or skins in a lime solution to loosen the hair, wool, and epidermis so they can be removed easily during dehairing. It is one of the most important steps in the unhairing stage of leather tanning.
- Loosens hair and wool from the hide or skin
- Removes the epidermis (outer skin layer)
- Swells the hide or skin to make it easier to work with
- Slows the growth of bacteria while the hide is in the lime
- Opens up the fibre structure so that tanning liquor can enter evenly later
Lime (calcium hydroxide) is an alkaline substance. When a hide or skin is dipped in the solution:
- The alkali breaks down the proteins that hold the hair and epidermis in place
- The hide absorbs water and swells, opening up its structure
- Grease and dirt are partially emulsified and removed
- Select and grade — Sort the hides and skins by kind, size and thickness, and lime similar ones together, because thick cattle hides need much longer than thin goat skins. Set aside any with bad cuts or signs of rotting.
- Wash and soak — Wash off dung, blood and salt, and soak dried or salted hides in clean water until they are as soft as fresh ones. A hide that is still hard in places will not take up lime evenly.
- Inspect — Check that each hide is clean and soft all over, and trim off loose scraps with a kitchen knife.
- Set up — Place the plastic containers on level ground in the working shade, and set the tannery beam and water horse nearby, ready for draining and dehairing.
-
Prepare the lime solution — First estimate the water: the hide must be fully covered and free to move, which takes roughly 4 to 5 litres for every kilogram of soaked hide. Pour the water into a plastic container, then add slaked lime (calcium hydroxide powder) a little at a time while stirring with a wooden stick. A common strength is about 500 g to 1 kg of lime for every 10 litres of water. Most of the lime does not dissolve; it hangs in the water as a milky liquid and then settles, so stir again just before the hide goes in.
-
Dip the hide or skin — Lower the prepared hide or skin into the lime solution with gloved hands or a stick and spread it out. The material must be completely covered, with no folds sticking out of the liquid.
-
Agitate regularly — Two or three times a day, lift the hides out, stir up the lime that has settled at the bottom and put the hides back in a different order, so that every part takes up lime evenly.
-
Monitor the time — Lime works slowly. With lime alone, goat and sheep skins often need about 3 to 6 days and cattle hides a week or more. Thicker hides and cool weather need longer. Keep the container covered and in the working shade.
-
Check for readiness — Test each day by rubbing the hair with a gloved thumb, especially on the neck and backbone, where it holds longest. The hide is ready when the hair and epidermis slip off easily everywhere and the hide feels swollen and slippery. Do not leave it in longer than needed: over-limed hides give loose, weak leather.
-
Remove and drain — Take the hide out of the solution and allow excess lime water to drip off, over the container or on a water horse, before proceeding to the dehairing step.
-
Wash the pelt — Rinse the limed hide (now called a pelt) in clean water to remove loose lime and dirt from the surface before it goes onto the tannery beam for dehairing. Never let a limed pelt dry out or lie in the sun.
- Wear rubber gloves and a mask when handling lime powder and lime solution
- Wear safety boots and an overall or overcoat to protect your body
- Work in a well-ventilated or shaded area (working shade)
- Avoid direct skin contact with lime solution as it is caustic: it burns the skin slowly, often without pain at first
- Protect your eyes with goggles or safety glasses when mixing and stirring, because lime in the eye can cause blindness
- Use slaked (hydrated) lime, not quicklime, which becomes dangerously hot in water. Add the lime to the water gently to avoid dust and splashes
- First aid: wash lime off the skin with plenty of clean water. If lime gets into an eye, rinse it at once with clean running water for at least 15 minutes, holding the eyelid open, and go to a health facility
- Keep the lime container covered and out of reach of children and animals
A tanner in Mwanza has one washed and soaked goat skin to process. Wearing gloves, a mask and eye protection, she stirs 500 g of slaked lime into 10 litres of water. She lowers the skin in until it is completely covered. Each morning and evening she lifts it out, stirs up the lime and puts it back. On the fourth day she rubs the hair on the neck with her gloved thumb — the hair comes off easily when pulled. The skin is then ready for the next step of scraping off the loosened hair and epidermis.
- Dipping always comes after soaking and before mechanical dehairing
- Lime solution must be the right strength — too weak a solution will not loosen the hair, and leaving the hide in for too long gives loose, weak leather
- Always rinse hands and tools after working with lime solution
- Proper dipping gives an evenly limed pelt that is easy to dehair and tans evenly
- Precise work matters: measure the lime and water, keep every part of the hide covered and test the hair each day, because under-limed patches keep their hair and over-limed hides are weakened
Leather is named by the animal it comes from and by the way it is tanned. Hides come from large animals such as cattle and give thick leather for soles, belts and straps. Skins come from goats and sheep and give thin, soft leather for shoe uppers, linings and bags. Vegetable-tanned leather is tanned with plant materials such as bark and is firm. Chrome-tanned leather is made in factories with chromium salts and is soft. All of these are limed first, because the hair must come off. Only leathers that keep their hair, such as rugs, are not limed.
- Rinse the stirring stick, buckets and gloves with clean water and store them dry. Never use these containers for food or drinking water
- Keep unused lime dry in a closed, labelled container
- Lime solution can be used again for the next batch with a little fresh lime added. When it is finally thrown away, never pour it into a stream, pond or well or onto crops: pour it into a soak pit well away from water sources
- Store limed pelts wet, never dry. Keep them under clean water or wet gunny bags in the shade, and dehair them the same day
A small-scale tanner in Arusha who processes hides from local cattle can use the dipping technique to prepare each hide before selling semi-processed leather to craftsmen who make belts, bags, and sandals. By properly dipping hides in lime solution, the tanner increases the value of the raw material — a well-prepared hide fetches a better price at the market than one that is poorly processed, helping the tanner earn more income from the same number of animals.
Jinsi utakavyotathminiwaTathmini ya mchakato · Tathmini ya matokeo · Tathmini ya maarifa
Tathmini ya mchakato
The student should be able to:
- Select material
- Select tools and equipment
- Set tannery beams
- Grade raw hides and skins
- Wash hides and skins
- Inspect for quality
- Estimate the amount of water
- Prepare lime solution
- Dip skins and hides into lime solution
- Steer and mix
- Wash the pelt
- Clean the pelt
- Observe safety
- Clean tools and equipment
- Store pelt
- Store tools and equipment
Tathmini ya matokeo
Raw hides and skin are soaked in lime solution and completely absorbed as per required specifications
Tathmini ya maarifa
Knowledge evidence:
Detailed knowledge of:
Method used: The student should explain how to:
- Perform dipping of hides and skins
- Prepare pelt for next stages
Principles: The student should explain the principles related to: Dipping hides and skins into lime solution
Theories: The student should explain:
- Types of leathers
- Functions of lime in pelt
- Importance of precise and detailed work while performing dipping hides and skins lime solution
Circumstantial knowledge:
Detailed knowledge of:
- Safety precautions pertaining to handling materials
Swali
What is the main purpose of dipping hides or skins in lime solution?
Ingia ili kuwasilisha jibu lako na lihesabiwe katika umahiri wako.
Ingia ili kufanya mazoeziMwalimu
Umekwama? Niulize chochote kuhusu mada hii.
Ingia ili kumuuliza Mwalimu wa AI wa Sonza kuhusu swali hili.
Ingia ili kuulizaMajadiliano
Hakuna maswali bado